Hypertherm V9 Series Phoenix Rev.11 Uživatelský manuál stáhnout pdf (Strana 188)

100

101

188 Phoenix 9.76.0 Installation and Setup Manual 806410

8–Diagnostics

To test the operator console:

1. From the Main screen, select Setups > Diagnostics > Operator Interface.

2. To test the USB port, touch it on the picture on the Operator Interface screen then follow the instructions on the

screen.

3. To test the lights for Station 1 or 2, touch the corresponding light on the picture on the Operator Interface screen

then follow the instructions on the screen.

4. You can also operate any component on the front panel of the CNC and watch the corresponding component on the

screen. Verify that the operation of the component on the screen matches what you do on the panel

If the test for a single component fails, replace that component. If multiple components fail, contact your OEM or system

integrator to replace the ribbon cable to the front panel board, the front panel board, or both.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 293 294

Komentáře k této Příručce

Žádné komentáře

Hypertherm V9 Series Phoenix Rev.11 Uživatelský manuál Strana 188

Komentáře k této Příručce

Související produkty a manuály pro Software Hypertherm V9 Series Phoenix Rev.11